插頭絕緣護套耐磨損試驗儀IN-1 產品概述：本置符合GB2099.1-2008圖28,TEC 60884-1圖28和BS 1363圖9的準要求,適用于檢測插頭的插銷絕緣襯套之磨損試驗。 工作源：AC220V 50HZ； 工作次數：1～999999 ； 刮磨頻率：30±1往返周期； 壓力荷重：4-0.1N； 工作行程：9mm ； 工位：?jiǎn)喂の唬–TZ-2型為雙工位）。 Insulation Sleeves of Plug Pins Abrasion Test Apparatus IN-1 Products Information Product details: Model IN-1: The test apparatus comprises a horizontally disposed beam, which is pivoted about its centre point. A short length of steel wire, 1 mm in diameter and bent into a U-shape, the base of the U being straight, is rigidly attached, at both ends, to one end of the beam, so that the straight part projects below the beam and is parallel to the axis of the beam pivot. The plug is held by a suitable clamp in such a position that the straight part of the steel wire rests on the plug pin, perpendicular to it. The pin slopes downwards at an angle of 10° to the horizontal. The beam is loaded so that the wire exerts a force of 4 N on the pin. The plug is moved backwards and forwards in a horizontal direction in the plane of the axis of the beam, so that the wire rubs along the pin. The length of the pin thus abraded is approximately 9 mm, of which approximately 7 mm is over the insulating sleeve. The number of movements is 20 000 (10 000 in each direction) and the rate of operation is 30 movements per minute. The test is made on one pin of each specimen.